FAQ » 0x8007045a ERROR_DLL_I...
Export

0x8007045a ERROR_DLL_INIT_FAILED: How to Fix it

Before your try out our tested solutions, you should:

  • Stop your VPN: Using VPN might hinder the update process. Try switching it off and see if that helps.
  • Restart your PC: Sometimes, a simple reboot could resolve most of the Windows update errors, but if you’re stuck, proceed to the solutions below:

  1. Run Windows Update Troubleshooter: Windows has a built-in troubleshooter that can automatically detect and fix common update-related problems. Follow these steps:

    • Press the Windows key + I to open the Settings app.
    • Click on "Update & Security" and go to the "Troubleshoot" tab.
    • Under "Get up and running," select "Windows Update" and click on "Run the troubleshooter."
    • Follow the on-screen instructions to complete the troubleshooting process.
  2. Check your internet connection: Ensure that you have a stable internet connection. Unstable or slow internet connection can interfere with the update process. Try restarting your router or connecting to a different network if possible.

  3. Reset Windows Update components: If the Windows Update service is corrupted, resetting its components may help. You can use the Command Prompt with administrative privileges to do this:

    • Press the Windows key, type "cmd," right-click on "Command Prompt," and select "Run as administrator."
    • In the Command Prompt window, enter the following commands one by one, pressing Enter after each:
      net stop wuauserv net stop cryptSvc net stop bits net stop msiserver ren C:\Windows\SoftwareDistribution SoftwareDistribution.old ren C:\Windows\System32\catroot2 catroot2.old net start wuauserv net start cryptSvc net start bits net start msiserver
    • After running these commands, close the Command Prompt and try updating Windows again.

  4. Perform a clean boot: Sometimes, third-party software or services can interfere with Windows Update. Performing a clean boot will start your computer with a minimal set of drivers and startup programs, which can help identify any conflicts. Here's how:

    • Press the Windows key + R, type "msconfig," and press Enter.
    • In the System Configuration window, go to the "Services" tab, check the box that says "Hide all Microsoft services," and click on "Disable all."
    • Go to the "Startup" tab and click on "Open Task Manager."
    • In the Task Manager window, disable all startup programs by right-clicking on each and selecting "Disable."
    • Close the Task Manager and go back to the System Configuration window. Click on "OK" and then restart your computer.
    • After the restart, try updating Windows again. If the update is successful, you can gradually enable the disabled services and startup programs to identify the one causing the issue.

However considering you have already purchased Restoro and would like us to assist you in doing that utilizing a remote session, please contact our support and they will be happy to help you.

No Comments
Back to top